聯系我們
18560023440
王經理:18560023440
地址:山東省德州市齊河縣經濟開發區齊眾大道7號-2車間

雕刻機如何對于濾波器進行添加?
來源:http://m.xacfgd.com.cn 時間:2020-12-23
雕刻機由于一樣通常步進電機和驅動器外殼未接納鋁、鈦、鎂合金外殼舉行磁屏蔽,因此對高敏捷的吸收機體系造成滋擾,使其無法事情,而且污染電源,造成控制體系的單片機和上位機無法舉行通訊,嚴峻者造成單片機去世機,給正常利用造成了困難,因此滋擾題目必須加以辦理。
Engraving machine as usual stepper motor and driver shell does not accept aluminum, titanium, magnesium alloy shell for magnetic shielding, so the high agility of the absorption machine system caused disturbance, make it unable to do things, and pollution of power supply, resulting in the control system of single-chip microcomputer and upper computer can not carry out communication, severe cause single-chip microcomputer death machine, to normal use caused difficulties, so disturbance The subject must be dealt with.


可接納如下步伐加以辦理:
The following procedures are acceptable:
A.加裝電源濾波器,淘汰對交換電源的污染。
A. Install power filter to eliminate the pollution of switching power supply.
B.“一點接地”原則。將電源濾波器的地、驅動器PE(地)(驅動器與機箱底板絕緣)、控制脈沖PULSE-和偏向脈沖DIR-短接后的引出線、電機接地線、驅動器與電機之間電纜防護套、驅動器屏蔽線均接到機箱壁上的接地柱上,并要求打仗精良。
B. "One point grounding" principle. Connect the ground of the power filter, the driver PE (ground) (the driver is insulated from the chassis bottom plate), the outgoing line after the control pulse pulse - and the bias pulse dir - are short circuited, the motor ground wire, the cable protective sleeve between the driver and the motor, and the driver shield wire are connected to the grounding column on the cabinet wall, and the combat is required to be excellent.
C.只管即便加大控制線與電源線(L、N)、電機驅動線(U、V、W)之間的間隔,制止交織.好比我們在處置處罰雙軸驅動體系中兩個處在統一機箱的驅動器安置位置時,一個驅動器銘牌朝前,另一個則朝后,并在布局部署上使這些引線只管即便短。
C. For example, when two drivers in the same chassis are placed in the same position, one driver's name plate should face forward, the other should face backward, and the layout and deployment should make these leads even short.
D.利用屏蔽線減輕外界對本身的滋擾,或本身(電源線)對外界的滋擾。
D. Use shielded wire to reduce the external disturbance to itself, or itself (power line) to the external disturbance.
以上就會3050保麗龍雕刻機小編為大家整理的相關內容,希望可以幫助大家,如了解更多的精彩內容請關注:http://m.xacfgd.com.cn會有更多精彩內容呈現。
The above will be 3050 styrofoam engraving machine for you to sort out the relevant content, hope to help you, if you know more wonderful content, please pay attention to: http://m.xacfgd.com.cn There will be more wonderful content to present.
- 木工雕刻機
- 1325木工雕刻機獨...
- 1325木工雕刻機
- 1325木工鏤空花格...
- 1225型平雕圓雕一...
相關產品: